Halsey Taylor SJ32W-Q 32 GPH Water-Cooled Remote Water Chiller

Specification Sheet

Installation Instructions

Spec Sheet

Install Instructions

Specification Sheet

---

Installation Instructions

The Halsey Taylor SJ32W Water-Cooled Remote Water Chiller delivers 31.9 GPH (gallons per hour) of 50°F water at 90°F ambient and 80°F inlet water. Designed for use with any drinking fountain. The compressor is hermetically sealed. Manufacturer certifies the unit to be lead free as defined by the Safe Drinking Water Act. The system is controlled by adjustable thermostat. Complies with ARI Standard 1010.

Features:

• Fountain Cabinet:
  Manufactured of rust-resistant heavy gauge galvanized steel. Front and rear panels removable for servicing.
• Plumbing Connections:
  3/8" O.D. inlet and outlet.
• Electrical Connection:
  7/8" diameter opening for conduit connection.
• Cooling Coil and Storage Tank
  Combination tube/tank type. Tube portion is continuous coil of copper-tubing.
• Temperature Control:
  Positive sensing thermostat for controlling temperature of evaporator/chiller storage water. Factory set for 40°F water. Adjustable to 50°.
• Condenser:
  Water-cooled for quiet performance in demanding environments.
• Refrigeration System:
  System uses R134A refrigerant. Test pressures, highside 325 PSIG. lowside 140 PSIG. Protected by Halsey Taylor's Limited 5 Year Warranty.
• Ventilation:
  It is important to insure proper ventilation. Allow a minimum clearance of 6" (152mm) in front and 3" (76mm) in the rear of the unit. If unit is to be installed in an enclosure, allow the following clearances around unit: 1 inch (25mm) on each side, 3 inches (76mm) in the rear and 3 inches (76mm) inches above wall.
• Electrical:
  Furnished with 6" leads enclosed in junction box for direct connection to standard 115 volt, 60 Hz, single phase.

Halsey Taylor SJ32W Category:

• Halsey Taylor Remote Water Chillers

Product Details