The Halsey Taylor HVR8-WF Water Cooler is a self-contained, filtered, electric refrigerated wall-mounted unit. Delivers 7.8 GPH of 50°F water at 90°F ambient and 80°F inlet water and has a stainless steel basin with integral drain strainer. Bubbler is one-piece, vandal-resistant. Separate valve and automatic stream regulator are mounted within cabinet. Refrigeration system employs high efficiency and positive start compressor using R134A. Non-pressurized tank with totally encapsulated insulation can be controlled by positive sensing thermostat. Push-bar water activation controls.
When properly installed, unit meets state and federal requirements as defined by the Americans with Disabilities Act for both children or adults. Unit is certified to NSF/ANSI 61 and meets requirements of the Safe Drinking Water Act. Unit complies with ARI Standard 1010.
These Water Coolers comply with the requirements of A.D.A. (Americans with Disabilities Act) when properly installed. Also meets the guidelines for children's environments providing the floor to orifice height is 30" or less and proper clear floor space is provided for parallel approach. (Based on Architectural and Transportation Barriers Compliance Board final ruling.) Check Local and State Codes.
No Lead Design:
These Water Coolers are certified to be lead-free as defined by the Safe Drinking Water Act. Halsey Taylor Water Coolers are manufactured with a waterway system utilizing copper components and completely lead-free materials. These waterways have no lead because all lead materials, such as leaded brass, have been removed. All joints are brazed using silver solder only. No lead solder is permitted. A strainer with an easily cleanable screen is provided to allow trapping and convenient removal of waterborne particulate of 140 microns and larger prior to their entry into the water cooler.
Aqua Sentry® Filter System:
Equipped with the Aqua Sentry HWF142 lead reduction system which is designed to remove cysts, such as cryptrosporidium and giardia, lead particles and chlorine taste and odor. The filter has been tested to the following NSF International standards: NSF/ANSI Standards 42 Chlorine, and Taste and Odor. NSF/ANSI Standard 53 for Reduction of Lead and Cyst. Features include Quick-Disconnect fittings on each end of the in-line filter. The filter contains a carbon block with lead sorbent media and the housing is made of rust and corrosion free plastic. Filter should be replaced every 750 gallons (2839 liters) or approximately 6 months after installation. Use part number 56191C when ordering replacement filter. Halsey Taylor recommends that you replace this filter annually.
- Cooler Cabinet:
Stainless steel panels resists wear and corrosion. Durable satin finish helps hide water spots and fingerprints.
- Cooler Top:
Non-corrosive stainless steel cooler top, number 300 series with satin finish resists stains and corrosion and is easy to maintain. Anti-splash design reduces splatter. Contoured to insure proper drainage.
Vandal-resistant bubbler is one-piece, chromeplated. Unit has integral hood guard design to prevent contamination from other users, airborne deposits and tampering.
- Pushbutton Actuation Mechanism:
Self-closing, vandal-resistant pushbutton does not require grasping or twisting.
- Automatic Stream Height Regulator:
Self-closing assembly is located inside unit to prevent tampering. Unit resists corrosion and liming. A constant stream height is automatically maintained under line pressures that vary from 20 to 105 psi.
- Inlet Strainer:
Easily cleaned in-line strainer screen traps particles of 140 microns or larger before they enter the waterway.
- Temperature Control:
Positive sensing thermostat for controlling temperature of storage tank water. Factory set at 50°F. Adjustable +/- 5°F
- Storage Tank:
Non-pressurized stainless steel evaporator/storage tank for long life. Waterways are certified to NSF/ANSI 61, far exceeding the requirements of the Safe Drinking Water Act.
- Refrigeration System:
Hermetically sealed, positive start compressor with lifetime lubrication and built-in overload protection, efficient capillary sizing, large capacity dryer-strainer, and self-lubricated fan cools copper/aluminum condenser. System uses R134A refrigerant. Protected by Halsey Taylor's Limited 5 Year Warranty.
Insure proper ventilation by maintaining 6" (152mm) minimum clearance from cabinet louvers to wall.
- Note: Adding any of the above accessories may delay shipment
|Manufacturer ||Halsey Taylor|
|Model # ||HVR8-WF-ADA|
|ADA Compliant ||Yes|
|Barrier Free ||Yes|
|Cooling Capacity ||8 GPH|
|Freeze Resistant ||No|
|GreenSpec Listed ||No|
|Installation Type ||Wall Mounted|
|Outdoor Rated ||No|
|Vandal Resistant ||Yes|