The Elkay EZSTL8LC Water Cooler (Elkay EZSTL8C Water Cooler) is a self-contained, wall hung electric refrigerated unit. Chilling capacity of 50°F drinking water, based upon 80°F inlet water and 90°F ambient. The Elkay EZSTL8LC has self-closing Easy-Touch Controls on front, left and right of each unit and a hooded stream projector with Easy-Touch Controls that require less than 3 pounds of force to activate commercial-grade solenoid based flow control. The Elkay EZSTL8LC has a patented* valve with built-in flow regulator provide constant stream from 20 to 105 psi water pressure. Bubbler orifice fully protected to meet all sanitary codes. The Elkay EZSTL8LC water cooler consists of a refrigerated lower unit which requires a water supply, drain outlet and electrical supply. NOTE: Minimum 40 psi supply line pressure required in special circumstances where both sides of bi-level are in use simultaneously to ensure adequate stream height. Does not apply to non-refrigerated units.
The Elkay water fountain EZSTL8LC complies with the requirements of A.D.A. (Americans with Disabilities Act) when properly installed. Also meets the guidelines for children's environments providing the floor to orifice height is 30" or less and proper clear floor space is provided for parallel approach. (Based on Architectural and Transportation Barriers Compliance Board final ruling.) Check Local and State Codes.
No Lead Design:
The Elkay EZSTL8LC is certified to be lead-free as defined by the Safe Drinking Water Act. Elkay Water Coolers are manufactured with a waterway system utilizing copper components and completely lead-free materials. These waterways have no lead because all lead materials, such as leaded brass, have been removed. All joints are brazed using silver solder only. No lead solder is permitted. A strainer with an easily cleanable screen is provided to allow trapping and convenient removal of waterborne particulate of 140 microns and larger prior to their entry into the water cooler.
Elkay EZSTL8LC Cooling System:
- Motor Compressor:
Hermetically sealed, reciprocating type, 115V, 60 Hz single phase. Sealed-in lifetime oil supply. Equipped with electric cord and three prong molded rubber plug (domestic models).
Fan cooled, copper tube with aluminum fins. Fan motor is permanently lubricated.
- Cooling Unit:
Combination tube-tank type. Self cleansing. Tube portion is continuous coil of copper tubing. Tank is stainless steel. Fully insulated with EPS foam which meets Underwriters Laboratories Inc. requirements for self-extinguishing material.
- Refrigerant Control:
Refrigerant HFC-134a is controlled by accurately calibrated capillary tube for positively trouble-free operation.
- Temperature Control:
Enclosed adjustable thermostat is factory preset. Requires no adjustment other than for altitude requirements. Easily accessible.
Elkay EZSTL8LC Construction:
One piece polished to a uniform Elkay bright luster finish. Basin has integral drain grid, embossed bubbler pad. No exposed fasteners.
- Stainless Steel Basin:
Galvanized structural steel chassis supports refrigeration system and fastens to wall. Provides increased structural integrity and rigidity to cooler.
- Exclusive Flexi-Guard® Safety Bubbler:
Innovative design utilizes an infused anti-microbial pliable polyester elastomer to prevent accidental mouth injuries. Flexes on impact, then returns to original position. Strong. Abrasion-resistant. Anti-sweat. Keyed in location to prevent rotation.
- Upper Shroud:
Contoured shock-absorbing, provides additional protection against accidental injury. No exposed fasteners.
- Lower Shroud:
One piece easy to remove and replace. Allows access to internal components from three sides.
Cabinet design allows for flush to wall mounting. No recess space is required.
- Color Selection:
Unless otherwise specified cabinet is two-tone gray on upper shroud with textured gray lower shroud. Stainless Steel lower shroud available at extra cost.
Elkay EZSTL8LC Category: