Download Spec Sheet | Download Parts Breakdown Cabinet Manufactured of rust-resistant heavy gauge galvanized steel. Removable service panels. Plumbing Connections 3⁄8" O.D. inlet and outlet. Electrial Connection 7/8" diameter opening for conduit connection. Cooling Coil and Storage Tank Combination tube/tank type. Tube portion is continuous coil of copper-tubing. Temperature Control Thermostat for cooling and storage tank is factory set for 50° F water. Adjustable ± 5° F. Fan Motor Unit bearing self-lubricating type for maintenance-free longer life. Condenser Copper/aluminum construction with associated shroud. Refrigeration System Hermetically sealed, positive start compressor with lifetime lubrication and built-in overload protection, efficient capillary sizing, large capacity dryer-strainer, and self-lubricated fan cools copper/aluminum condenser. System uses R134A refrigerant. Test pressures, highside 325 psig., lowside 140 psig. Protected by Halsey Taylor’s Limited 5 Year Warranty. Electrial Furnished with 6" leads enclosed in junction box for direct connection to standard 115 volt, 60 Hz, single phase. Ventilation It is important to insure proper ventilation. Allow a minimum clearace of 6" (152mm) in front and 3"(76mm) in the rear of the unit. If unit is to be installed in an enclosure, allow the following clearances around unit: 1 inch (25mm) on each side, 3 inches (76mm) in the rear and 3 inches (76mm) inches above wall. Suggested Specification Shall deliver 10 GPH of 50°F water at 90°F ambient and 80°F inlet water. Designed for use with any drinking fountain. Compressor shall be hermetically sealed. Manufacturer shall certify unit to be lead free as defined by the Safe Drinking Water Act. System controlled by adjustable thermostat. Complies with ARI Standard 1010. SJ5 can serve 1 fountain. Product Details | Manufacturer | Halsey Taylor | | Model # | SJ10-Q | | Cooling Capacity | 10 GPH | | Freeze Resistant | No | | Outdoor Rated | No | | Refrigerated | Yes | |
